66 12 100 Removing and installing/replacing slide-in unit for radio control key

WARNING: This page is about a different variant/trim than selected.

Lever out trim (1) with special tool 00 9 340 at retaining points (2) in direction of arrow.

Fig 1: Removing Trim Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Pull back slide-in unit for radio control key (2) with associated ribbon cable.

IMPORTANT: Carefully unlock ribbon cable plug connection.
Replace the ribbon cable if damaged.
The ribbon cable leads to:

Remove slide-in unit for radio control key (2).

Fig 2: Identifying Radio Control Key With Screws

Courtesy of BMW OF NORTH AMERICA, INC.