61 35 015 Removing and installing (replacing) control unit for Car Access System
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION)
.
NOTE:
The comfort access system is a radio-based system and can be interfered with by radio waves from other systems (e.g. mobile phone).
Necessary preliminary tasks
- Remove TRIM FOR PEDAL ASSEMBLY
Disconnect plug connection (2).
IMPORTANT:
Carefully disconnect plug connection for ribbon cable (1).
Replace the ribbon cable if damaged.
The ribbon cable leads to:
Replace the ribbon cable if damaged.
The ribbon cable leads to:
Release screw (3).
Feed out control unit for Car Access System (4) to left and remove in downward direction.
Installation:
Feed guide (1) of control unit for Car Access System (2) correctly into associated mounting.
Replacement:
- Carry out vehicle programming and encoding
- Version with independent heating: Initialize Telestart hand transmitter See INITIALIZING TELESTART HANDHELD TRANSMITTER (T93) (FROM BUILD DATE 03/2007) or INITIALIZING TELESTART HAND TRANSMITTER (T90) (UP TO BUILD DATE 03/2007) .