52 26 412 Replacing right backrest cover for rear seat

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Release screw (1).

Tightening torque 52 26 04AZ .

Remove outer mount (2).

Fig 1: Identifying Outer Mount And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out backrest cover all round with special tool 00 9 317 or screwdriver.

Remove backrest cover with padding from carrier section.

Fig 2: Removing Backrest Cover Welt Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and padding:

Installation:

Insert new retainers with special tool 52 0 050 PLIERS .

Fig 3: Identifying Retainers On Cover And Padding

Courtesy of BMW OF NORTH AMERICA, INC.

In so doing, enclose wire in padding and trim wire of cover.

Only when replacing seat cover for E90 with build date up to 03/06:

Pull liner off foam strip (1).

Stick on foam strip flush with top edge of padding.

Short protruding foam strip.

Fig 4: Identifying Foam Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover:

Fig 5: Identifying Trim Location On Cover

Courtesy of BMW OF NORTH AMERICA, INC.