34 41 220 Removing and installing/renewing all parking brake shoes

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Remove rear BRAKE DISC

Lock adjuster unit (ASZE).

Actuate parking brake lever. Connect special tool 32 1 030 LEVER . Press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Installation:

Unlock adjuster unit (ASZE).

Lever out restraining hook (2) with a suitable screwdriver.

Restraining hook (2) must detach from stop (1) of adjusting spring.

Fig 1: Pressing Spring Back To Retaining Hook Using Special Tool (32 1 030)

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation:

Return spring (1) must not be overelongated.

Check and if necessary replace return spring (1).

Pay attention to installation position of adjusting screw (2).

Apply a thin coat of grease to bush and screw threads.

Fig 2: Identifying Return Spring With Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation:

Return spring (1) must not be overelongated.

Check and if necessary replace return spring (1).

Fig 3: Identifying Return Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Twist roll pins (1) 90° with special tool 34 4 000 and detach.

Remove brake pads (2).

Fig 4: Twisting Roll Pins Using Special Tool 34 4 000

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Adjusting PARKING BRAKE