51 12 156 Removing and installing rear bumper trim

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Lever out cover (1) and release screw underneath.

Fig 1: Identifying Rear Bumper Trim Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on left/right.

Bend wheel arch trim (2) in area (A) to one side and release screw (3) on left/right.

Fig 2: Identifying Wheel Arch Trim Bending Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 3: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Do not detach bumper trim (1) at sides
The following work must be carried out with a second person assisting:

Pull bumper trim (1) towards rear and release from catches (2).

Fig 4: Pulling Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Press down catch (2).

Remove bumper trim (1) towards rear with aid of a 2nd person.

If necessary, disconnect plug connection on ultrasonic transducers.

Fig 5: Identifying Bumper Trim And Catch

Courtesy of BMW OF NORTH AMERICA, INC.