63 21 180 Removing and installing/replacing left or right rear light (in side panel)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Remove cover (1) in direction of arrow from luggage compartment wheel arch trim (2).

Fig 1: Removing Cover From Luggage Compartment Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock locking clip (2) in direction of arrow and remove socket housing (3) from rear light (4).

Fig 2: Removing Socket Housing From Rear Light

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1), tightening torque 63 21 1AZ .

Remove rear light (2) in outwards direction from side panel (3).

Installation:

Make sure gap is uniform all round between rear light (2) and side panel (3).

Fig 3: Identifying Rear Light, Side Panel And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure seal (1) is correctly seated on rear light (2).

Fig 4: Identifying Seal On Rear Light

Courtesy of BMW OF NORTH AMERICA, INC.