61 31... Removing and installing/replacing parking lock from series status 09/2008
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION)
.
Necessary preliminary tasks
- Remove gear selector switch
- Remove PARKING LOCK CABLE FROM TRANSMISSION
Release screws (1).
Feed rubber seal (2) completely out of gear selector switch (3).
Release parking lock (4) at points (5) and remove in direction of arrow.
Installation:
Make sure parking lock (4) is exactly seated on gear selector switch (3).
Make sure rubber seal (2) is correctly seated.
Install gear selector switch (1).
Install PARKING LOCK CABLE ON TRANSMISSION .
Installation:
Make sure rubber seal is correctly seated.
Release handle (1) from gear selector switch (2).
Withdraw transportation lock (3) from parking lock (4).
US version only:
Transmission emergency release (5) is provided with a grey cap.