51 46 001 Removing and installing panel for rear window shelf (parcel shelf)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks
- Remove left/right TRIM PANEL FOR ROOF PILLAR (C-pillar)
- Remove REAR MID-RANGE SPEAKER on left/right
- Release bottom rear seat belts . See 7211101 REMOVING AND INSTALLING/REPLACING REAR CENTRE SEAT BELT or 7211092 REMOVING AND INSTALLING/REPLACING REAR LEFT OR RIGHT SEAT BELTS .
Version with child seat holder:
- Remove all TOP TETHER EYELETS FOR CHILD SEAT
Version without through-loading system:
- Remove BACKREST for rear seats
Version with through-loading system:
- Remove TRIM ON REAR WINDOW SHELF
- Remove left/right ARMREST SIDE SECTIONS
Version with roller sun blind:
- If necessary, remove DRAWER in luggage compartment
Version with roller sun blind:
Release screws (1).
Tightening torque 51 46 3AZ .
Version with roller sun blind:
Disconnect connector (1).
All versions:
Remove plate (1).
Pay attention to catches (2).
Remove trim (1) and feed out from belt (3).
Version without through-loading system:
Release clips (2).
All versions:
Pull out rear window shelf (1) towards front and feed out belts (4).
Installation:
Make sure rear window shelf (1) is correctly fed under grid (3)