51 11 050 Removing and installing/replacing carrier for front bumper trim

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW Z4, 2007 BMW Z4, 2006 BMW Z4, 2005 BMW Z4, and 2004 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Remove Front Bumper Trim .

Release expander rivets (1) and remove impact absorber (2).

Fig 1: Releasing Expander Rivets (1) & Removing Impact Absorber (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1 and 2) on left/right and remove carrier (3). Tightening torque, see 51 11 5AZ in BODY EQUIPMENT - TIGHTENING TORQUES .

Fig 2: Releasing Screws (1 & 2) Removing Carrier (3)

Courtesy of BMW OF NORTH AMERICA, INC.