37 14 511 Replacing front ride-height sensor

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). Refer to 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE .

After installation:

Check headlight adjustment, correct if necessary, refer to 63 10 004 ADJUSTING HEADLIGHTS
Version with ride-height control: Carry out ride-height calibration, refer to 37 12 012 CARRY OUT RIDE-HEIGHT CALIBRATION
Initialize Run Flat Indicator, refer to 36 11 000 INITIALIZING TIRE DEFECT INDICATOR (RPA)

Disconnect plug connection (1).

Fig 1: Removing Ride-Height Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (2) and disconnect jointed rod.

Tightening torque 37 14 7AZ. Refer to INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES X5 (4.4i) N62 .

Unfasten screws (3) and remove ride-height sensor.

Installation:

Sensor lever must point outwards from ride-height sensor.

Tightening torque 37 14 6AZ. Refer to INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES X5 (4.4i) N62 .

Slacken nut (1).

Fig 2: Locating Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Holder must be located between both cast lugs (2).

Tightening torque 37 14 7AZ. Refer to INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES X5 (4.4i) N62 .