37 12 012 Carry Out Ride-Height Calibration
WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ride-height-calibration must be carried out after the following work:
- Replacement of control unit
- Replacement of wiring harness
- Replacement of ride-height sensor
Connect BMW diagnosis system.
Switch on ignition.
Carry out ride -height calibration (menu item: "Service function").
Version with Run Flat Indicator: initialize Run Flat Indicator, refer to 36 11 000 INITIALIZING TIRE DEFECT INDICATOR (RPA)
Version with Tyre Pressure Control: initialize Tyre Pressure Control