63 21 183 Removing and installing/replacing left or right rear light (on tailgate)

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 318

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks

Remove LUGGAGE COMPARTMENT LIGHT .

NOTE: For purposes of clarity, tailgate trim panel is shown removed.

Disconnect plug connection (1).

Release nut (2) and remove with retaining bracket (3).

Tightening torque 63 21 3AZ .

Fig 1: Identifying Plug Connection And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Tape off tailgate with suitable protective film (1).

Lever out rear light (2) with special tool 00 9 318 in direction of arrow.

Installation note:

Make sure that gap dimension is uniform all round between rear light (2) and tailgate.

Fig 2: Removing Rear Light Using Special Tool (00 9 318)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Position tabs (1) of rear light exactly over side edge of tailgate.

REMOVE BUTYL REMNANTS FROM TAILGATE.

Clean bonding surfaces of rear light (2) and tailgate with brake cleaner (BMW Parts Department 2 154 780) and allow to dry.

Fig 3: Identifying Rear Light And Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace the Butyl gasket with a sealing frame:

Make sure sealing frame (2) is correctly seated.

If necessary, replace SEALING FRAME (2).

Fig 4: Identifying Sealing Frame And Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove BULBS .