66 20 518 Removing and installing/replacing a front ultrasonic sensor (center)
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Remove FRONT BUMPER PANEL .
Disconnect plug connection (1) and unclamp ultrasonic sensor from retaining lugs (2).
Installation note:
Before installation of ultrasonic sensor on wiring harness, clean plug connection!
Retaining lugs (2) must not be damaged!
Make sure ultrasonic sensor is securely seated.
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).