37 14 511 Replacing front right ride-height sensor

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle.

NOTE: Jointed rod on upper control arm 37 14 5AZ .

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove front right WHEEL ARCH TRIM .

Disconnect plug connection (1).

Release nut (2) and disconnect jointed rod.

Installation:

Sensor lever (3) must point from ride-height sensor to right front wheel.

Replace self-locking nut.

Tightening torque 37 14 4AZ .

Fig 1: Identifying Sensor Lever, Plug Connection And Mounting Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (1) and remove ride-height sensor with bracket.

Installation:

Align ride-height sensor holder by means of lug (2) to opening under screw (1).

Tightening torque 37 14 1AZ .

Fig 2: Identifying Ride-Height Sensor Mounting Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove holder (2).

Tightening torque 37 14 3AZ .

Fig 3: Identifying Ride-Height Sensor Holder And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Carry out RIDE-HEIGHT CALIBRATION .
Check HEADLIGHT ADJUSTMENT , correct if necessary.