37 12 012 Carrying out ride height adjustment
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ride-height-calibration must be carried out after the following work:
- Removal/replacement of ride-height sensor or its control rod
- Replacement of wiring harness
- Replacement of air supply unit control unit
- Replacement of Vertical Dynamics Management control unit
Connect BMW diagnosis system.
Switch the ignition on.
Carry out ride-height-calibration (menu item: "Service function").
Version with Run Flat Indicator: initialize RUN FLAT INDICATOR .
Version with Tyre Pressure Control: carry out RESETTING .