65 50 011 Removing and installing (replacing) video module for on-board monitor

WARNING: This page is about a different car, the 2005 BMW 545i and 2004 BMW 545i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). Refer to 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary Preliminary Tasks:

Disconnect battery negative lead. Refer to 12 00 ... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
Remove luggage compartment trim on left side panel. Refer to 51 47 210 REMOVING AND INSTALLING/REPLACING TRUNK TRIM PANEL ON LEFT SIDE PANEL .

NOTE: Follow instructions for handling optical fibers. Refer to 61 00 ... NOTES ON HANDLING OPTICAL FIBERS .

Release screws (1).

Remove storage compartment (2) in direction of arrow from holder (3).

Installation:

Fig 1: Identifying Storage Compartment Retaining Screws

G03271887

Courtesy of BMW OF NORTH AMERICA, INC.

Do not mix up antenna connectors (1).

Mark antenna plugs (1) and disconnect.

Unfasten plug connection (2) and disconnect.

Release screws (3).

Remove video module for on-board monitor (4) in direction of arrow.

Fig 2: Locating On-Board Monitor Video Module Connectors

G03271888

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1) and remove holder (2) from video module for on-board monitor (3).

Fig 3: View Of Holder From On-Board Monitor Video Module

G03271889

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding. Refer to DIAGNOSIS PROGRAMMING/CODING .