LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2433 (Maintenance And General Information - Repair) >> Maintenance And General Data >> 00 11... Checking/topping up oil level in rear differential

00 11... Checking/topping up oil level in rear differential

WARNING: This page is about a different car, the 2010 BMW M6, 2009 BMW M6, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Risk of damage!
To avoid serious damage to the rear differential, it is essential to use only approved gear oils in the differential. See 2.0 APPROVED FINAL DRIVE OILS FOR FRONT AND REAR AXLE FINAL DRIVES WITH AND WITHOUT LIMITED SLIP OR VISCOUS COUPLING .

Undo oil filler plug (1).

Check oil level.

If necessary, pour in rear differential oil up to lower edge of opening for oil filler plug (1).

Fig 1: Identifying Oil Filler Plug
G04739596Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. Oil filler plug with sealing ring:

    Replace sealing ring (1).

    Tightening torque: see "3AZ" in table under 33 11 REAR DIFFERENTIAL CASE WITH COVER .

  2. Oil filler plug with O-ring:

    Replace oil filler plug (2).

    Tightening torque: see "9AZ" in table under 33 11 REAR DIFFERENTIAL CASE WITH COVER .

Fig 2: Identifying Oil Filler Plug With Sealing Ring
G04739597Courtesy of BMW OF NORTH AMERICA, INC.