41 51 080 Removing And Installing/Replacing Front Left Or Right Door

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Security version: 

Rear reflector is modified. New component must be trimmed and glued (this is described in the following).

Release screw on connector frame.

Fig 1: Locating Connector Frame Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws between both hinge elements at top and bottom.

Tightening torque: see 1AZ in 41 51 FRONT DOORS

Fig 2: Locating Screws Between Both Hinge Elements At Top And Bottom

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on door retainer.

Fig 3: Identifying Door Retainer Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unhinge door by moving upwards and placing it on a suitable surface.

Fig 4: Unhinge Door By Moving Upward And Placing On Suitable Surface

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Installation: 

If necessary, adjust front door  .

Fig 5: Pulling Plug Connection From Door Pillar

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only: 

Rivet down blind rivet nuts (1) for control unit.

Fig 6: Rivet Down Blind Rivet Nuts (1) For Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Security version: 

Trim grommet (1) on rear reflector rubber housing at edge (2) and glue with window adhesive  in same position as standard model.

Fig 7: Trim Grommet (1) On Rear Reflector Rubber Housing At Edge (2)

Courtesy of BMW OF NORTH AMERICA, INC.