33 17 005 Replacing rubber mount for rear differential mounting at rear

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

Remove REAR DIFFERENTIAL

Withdraw rubber mount with special tools 33 5 153 , 33 5 152 , 33 5 151 , 33 3 103 and 33 3 104.

NOTE: Make sure special tool 33 5 152 contacts rear axle carrier correctly.

Use ratchet ring wrench 33 5 105.

Fig 1: Identifying Rubber Mount With Special Tools (33 5 153, 33 5 152, 33 5 151, 33 3 103 And 33 3 104)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circo Light .

Align rubber mount horizontally by way of elongated hole (1).

Fig 2: Aligning Rubber Mount Horizontally By Way Of Elongated Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount (1) in special tool 33 5 154 .

Draw in rubber mount (1) with special tools 33 5 155 , 33 5 154 , 33 5 156 , 33 3 103 and 33 3 104 as far as it will go.

NOTE: Make sure special tools 33 5 154 and 33 5 156 contact rear axle carrier correctly.

Use ratchet ring wrench 33 5 105.

Fig 3: Identifying Rubber Mount With Special Tools (33 5 155, 33 5 154 And 33 5 156)

Courtesy of BMW OF NORTH AMERICA, INC.