37 14 521 Replacing front left ride-height sensor
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
NOTE:
Jointed rod on upper control arm 37 14 5AZ
.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Release coolant expansion tank and place to one side. See COOLANT EXPANSION TANK (N62TU/N52K/N54) or COOLANT EXPANSION TANK (N63) .
NOTE:
Level switch can slip out when coolant expansion tank is removed.
Release screw (1).
Installation note:
Align ride-height sensor holder by means of lug (2) to opening under screw (1).
Tightening torque 37 14 1AZ .
Disconnect plug connection (1).
Release nut (2) and disconnect jointed rod.
Installation note:
Sensor lever (3) must point from ride-height sensor to left front wheel.
Replace self-locking nut.
Tightening torque 37 14 4AZ .
Release screws (1) and remove holder (2).
Tightening torque 37 14 3AZ .
After installation:
- Carry out RIDE-HEIGHT-CALIBRATION
- Check HEADLIGHT ADJUSTMENT , correct if necessary