37 12 012 Carrying out ride-height adjustment
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ride-height-calibration must be carried out after the following work:
- Removal/replacement of ride-height sensor or its control rod
- Replacement of wiring harness
- Replacement of air supply unit control unit
- Replacement of Vertical Dynamics Management control unit
Connect BMW diagnosis system.
Switch on ignition.
Carry out ride-height-calibration (menu item: "Service function").
Version with Run Flat Indicator: initialize RUN FLAT INDICATOR
Version with Tyre Pressure Control: carry out RESETTING