61 12 067 Replacing wiring harness for rear bumper
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on handling wiring harnesses
and cables.
Necessary preliminary tasks:
- Remove rear bumper trim . See 51 12 156 REMOVING AND INSTALLING REAR BUMPER TRIM .
Disconnect plug connection (1).
Release cable tie (2).
Feed wiring harness for rear bumper (3) out of bumper trim (4) and remove.