64 11 872 Removing and Installing/Replacing Servodrive For Blending Flap (Right)

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors

Necessary preliminary tasks:

Remove right glovebox with housing. Refer to RIGHT GLOVEBOX WITH HOUSING (Coupe) or RIGHT GLOVEBOX WITH HOUSING (Convertible).
E87 only:
- Remove STORAGE COMPARTMENT .

Detach right footwell heating duct (1) in area (2) in direction of arrow.

Detach right footwell heating duct (1) with adapter (3) from heater/air conditioner and remove in direction of arrow from right rear compartment heating duct (4).

Fig 1: Detaching Right Footwell Heating Duct With Adapter From Heater/Air Conditioner

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure retainer (2) is correctly seated on right footwell heating duct (1).

Insert right footwell heating duct (1) with adapter (3) in right rear compartment heating duct (4).

Attach right footwell heating duct (1) in area (4) to heater/air conditioner. Make sure assembly is locked exactly at point (5).

Fig 2: Inserting Footwell Heating Duct With Adapter In Rear Compartment Heating Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release screws (2).

Detach servodrive for blending flap (3) in direction of arrow from heater/air conditioner (4).

Installation:

Place servodrive for blending flap (3) over guide pin (5).

Fig 3: Detaching Servodrive For Blending Flap From Heater/Air Conditioner

Courtesy of BMW OF NORTH AMERICA, INC.