Components Without Pre-Fitted Adhesive Tape

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Pull off liner* from adhesive tape
Position adhesive tape on component and stick on
Press down adhesive tape over entire bonding area
Continue with Components With Pre-Fitted Adhesive Tape .

*Liner is the protective film on the adhesive tape