Components With Pre-Fitted Adhesive Tape
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
- Pull off liner* from adhesive side (if bonding area is large, do not pull off liner completely)
- Align component in correct position on vehicle
- Press down component over entire bonding area
*Liner is the protective film on the adhesive tape