61 61 270 Removing And Installing Or Replacing Bracket For Windshield Wiper System Complete With Motor

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove cowl panel cover . See 51 13 115 REMOVING AND INSTALLING/REPLACING COWL PANEL COVER .
Remove both tension struts from spring strut dome.

Release screws (2) from left heater bulkhead (3).

Remove left heater bulkhead (3) towards top.

Unclip cable (1) for wiper motor from holder.

Release screws (5) for wiper bracket (4).

Tightening torque, see 61 61 6AZ in 61 61 WINDSHIELD WIPERS .

Remove wiper bracket (4) upwards.

Disconnect plug for wiper motor.

Fig 1: Identifying Left Heater Bulkhead And Wiper Bracket With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Before fitting the wiper arms, allow the windscreen wiper motor to run into the rest position.

To ensure that the windscreen wiper system functions properly, check/adjust the contact angle of the wiper arms to the windscreen.