61 61 Windshield Wipers
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
WINDSHIELD WIPERS - TORQUES SPECIFICATION TABLE
| - | Type | Thread | Tightening specification | Measure |
|---|---|---|---|---|
| 1AZ Wiper motor secured to wiper bracket | E52 | M6 | - | 9.9 Nm |
| 2AZ Parked position stop to wiper console | - | - | - | - |
| 3AZ Wiper contact pressure motor to wiper console | - | - | - | - |
| 4AZ Motor crank to wiper motor | E52 | M8 | - | 27 Nm |
| 5AZ Wiper shaft nut to body | - | - | - | - |
| 6AZ Wiper bracket to firewall | E52/E53/E60/E61/E63/E64/E65/E66/E67/E70/E71/E81/E82/E85/E86/E87/E88/E90/E91/E92/E93 | M6 | If necessary, observe tightening sequence. | 10 Nm |
| 7AZ Wiper bracket to rubber buffer | E53 | M6 | - | 10 Nm |
| 8AZ Wiper arms | E53 | - | Due to risk of releasing: check tightening torque after approx. 15 mins. settling time. | 30 Nm |
| 9AZ Wiper arms | E52 | - | - | 27 Nm |
| 10AZ Adjusting screw, wiper arm, right side | E65/E66/E67 | - | Due to risk of releasing: check tightening torque after approx. 15 mins. settling time. | 30 Nm |
| 11AZ Wiper arms | E85/E86 | - | - | 25 Nm |
| - | E90/E91/E92/E93 | M10 | - | 30 Nm |
| - | E70/E71/E81/E82/E87/E88 | M10 | - | 35 Nm |
| 12AZ Wiper arm, left side | E60/E61/E63/E64 | M10 | For torque, see inscription on wiper arm. Due to risk of releasing: check TT after approx. 50 mins. settling time. | 30 or 35 Nm |
| - | E65/E66/E67 | M10 | Due to risk of releasing: check tightening torque after approx. 15 mins. settling time. | 45 Nm |
| 13AZ Wiper arm, right side | E60/E61/E63/E64 | 2xM8 | For torque, see inscription on wiper arm. Due to risk of releasing: check TT after approx. 50 mins. settling time. | 20 Nm |
| - | E60/E61/E63/E64 | 1xM8 1xM10 |
Wiper arm without torque label. | 17 or 35 Nm |
| - | E65/E66/E67 | M10 | Due to risk of releasing: check tightening torque after approx. 15 mins. settling time. | 35 Nm |
| 14AZ Adjusting screw, wiper arm, right side | E60/E61/E63/E64 | - | - | 20 Nm |
| 15AZ Bearing block tension strut/cowl panel | E60/E61/E63/E64 | - | - | 24 Nm |
| 16AZ Nut to deflection lever | E65/E66/E67 | M10 | - | 30 Nm |