84 11 519 Removing and installing or replacing eject box

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove trim on storage compartment at rear . See 51 16... REMOVING AND INSTALLING/REPLACING TRIM FOR STORAGE COMPARTMENT AT REAR (CONVERTIBLE) or 51 16... REMOVING AND INSTALLING/REPLACING TRIM FOR STORAGE COMPARTMENT AT REAR (COUPE) .

Disconnect plug connection (1).

Installation:

Ensure correct cable routing (2)!

Fig 1: Identifying Plug Connection And Cable

G05780413

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cover (1) in direction of arrow.

Fig 2: Removing Cover

G05780414

Courtesy of BMW OF NORTH AMERICA, INC.

Lift eject box (1) with special tool 00 9 317 out of center armrest.

Feed out line (2) and remove eject box (1).

Installation:

Ensure correct cable routing.

Fig 3: Lifting Eject Box With Special Tool 00 9 317 Out Of Centre Armrest

G05780415

Courtesy of BMW OF NORTH AMERICA, INC.