51 16 210 Removing And Installing/Replacing Trim For Preselector Lever

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Risk of damage!

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Necessary preliminary tasks:

Remove gaiter for shift tower . See 51 16... Removing And Installing/Replacing Trim For Gearshift
Depending on equipment specification: Remove controller. See 61 31 195 REMOVING AND INSTALLING (REPLACING) FRONT CONTROLLER (UNTIL 9/08) or 61 31 195 REMOVING AND INSTALLING (REPLACING) FRONT CONTROLLER (FROM 9/08)

Pull trim (1) upwards and thereby release from clamps (2) and latch mechanisms (3).

Installation note:

Cables must not be jammed.

Clamps (2) and latch mechanisms (3) must not be damaged.

Fig 1: Identifying Trim, Retainers And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

If replacing with controller version: Provide trim (1) with recess (2) for controller (3).

NOTE: Recess (2) is marked on the underside of the trim (1).

Fig 2: Identifying Marking On Underside Of Trim

Courtesy of BMW OF NORTH AMERICA, INC.