61 31 195 Removing And Installing (Replacing) Front Controller (Until 9/08)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

00 9 317 TRIM PANEL WEDGE

Necessary preliminary tasks:

Remove knob for controller

IMPORTANT:

Risk of damage!

Install knob for controller only when controller is installed.

Lever gaiter (1) out of center console with special tool 00 9 317 and slide upwards.

Fig 1: Identifying Lever Gaiter

G05780016

Courtesy of BMW OF NORTH AMERICA, INC.

Press cable retaining plate (1) downwards to gain access to controller from below.

Fig 2: Pressing Cable Retaining Plate

G05780017

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Sharp edges on center console and on cable ties may cause injury.

Carry out this operation with care.

Insert hand between cable retaining plate (3) and center console (2).

Press controller (1) upwards out of catch.

Disconnect associated plug connection and remove controller (1).

Fig 3: Removing Controller

G05780018

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove controller (2) from trim (3).

Fig 4: Removing Controller & Screws

G05780019

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainers (1) of controller (2) must not be damaged or missing.

Fig 5: Identifying Retainers Of Controller

G05780020

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming/coding.