51 16 196 Removing And Installing/Replacing Cover For Center Armrest

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Risk of damage!

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Necessary preliminary tasks:

Remove trim on storage compartment at rear .

Unclip trim (1) on left/right.

Fig 1: Identifying Trim

G05779134

Courtesy of BMW OF NORTH AMERICA, INC.

Open cover (1).

Detach spring (2) on left/right.

Installation:

Make sure spring (2) is correctly seated

Fig 2: Identifying Spring & Cover

G05779135

Courtesy of BMW OF NORTH AMERICA, INC.

Press catches (1) together.

Pull out rotary shaft (2) on left/right.

Fig 3: Pulling Rotary Shaft

G05779136

Courtesy of BMW OF NORTH AMERICA, INC.

Fold cover (1) back until it feeds out of storage compartment (2).

Fig 4: Identifying Storage Compartment

G05779137

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace rubber damper (1) on left/right.

Fig 5: Identifying Rubber Damper

G05779138

Courtesy of BMW OF NORTH AMERICA, INC.