51 21 330 Removing And Installing/Replacing Window Cavity Cover Strip On Inner Front Door

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove outer window cavity cover strip
Remove front door trim

Pop window cavity cover strip (1) in direction of arrow out of front door.

Fig 1: Identifying Window Cavity Cover Strip Of Front Door

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Molded section (1) and retaining elements (2) of window cavity cover strip (3) must not be damaged.

Molded section (1) must be correctly fed into door.

Moisten window cavity cover strip (3) prior to fitting with approved anti-friction agent.

Fig 2: Identifying Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure window cavity cover strip (1) is installed in correct position on door (2) and door window glass (3).

Fig 3: Identifying Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.