51 21 300 Removing And Installing Or Replacing Window Cavity Cover Strip On Outside Of Left Or Right Front Door

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

00 9 324

IMPORTANT:

Observe procedure for using special tool 00 9 324 .

IMPORTANT:

Risk of damage!

If reusing the existing window cavity cover strip (1), make sure it is not bent.

Lever out window cavity cover strip (1) with special tool 00 9 324 (starting at B-pillar).

Fig 1: Identifying Lever Out Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Pull window cavity cover strip (1) out of door mirror (2) in direction of arrow.

Installation:

Moisten window cavity cover strip (1) prior to fitting with approved anti-friction agent .

Fig 2: Pulling Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

E92/E93 only:

Installation:

Notch (1) on window cavity cover strip (2) must be correctly located in guide (3) of cover strip (4).

Window cavity cover strip (2) must be flush at rear to door edge (5).

If cover strip (4) is not correctly fitted, window cavity cover strip (2) cannot be fitted flush with door edge (5).

If necessary, align cover strip (4).

Fig 3: Identifying Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.