51 14 110 Removing And Installing/Replacing Rear Model Designation
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The Instructions for number/letter combination cementing serve as the basis for these repair instructions and must be followed without fail.
Fitting dimensions (E82/E88):
Stick on adhesive tape (1) horizontally according to dimension "A".
Mark reference point (2) according to dimension "B".
Position model designation at reference point (2) and stick on.
Dimensions:
A = 23.5 mm
B = 26.5 mm
NOTE:
Measurements C, D and E are for information purposes only, as determined by carrier film.
118d: C = 5.5 mm, D = 8 mm, E = 13.5 mm
118i: C = 5.5 mm, D = 8 mm, E = 16 mm
120d ...123d: C = 8 mm, D = 6.5 mm, E = 13.5 mm
120i ...128i: C = 8 mm, D = 6.5 mm, E = 16 mm
135i: C = 6.8 mm, D = 6.5 mm, E = 16 mm