51 14... Instructions For Attaching Number/Letter Designation Combination

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The model designation is attached with adhesive and cannot be re-used.

The model designation must be attached at room temperature.

The model designation must be removed at stoveenameling temperatures exceeding 80°C.

Removing:

Coat nylon string or strong yarn with tensides (e.g. washing-up liquid).

Cut through adhesive layer and remove model designation (1) from rear lid (2).

Remove remainder of adhesive layer with adhesive remover (sourcing reference: BMW Parts Service).

Fig 1: Identifying Rear Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Assembly:

Number and letter combinations (1) of the model designation are not connected to each other and are supplied on a carrier film (2).

IMPORTANT:

Adhesive areas must be dry and free of dust and grease.

Once it has been cleaned, do not touch the adhesive area with bare hands.

Remove liner (3) (protective strip for adhesive surface).

Press on model designation firmly.

Remove carrier film (2).

Fig 2: Identifying Carrier Film

Courtesy of BMW OF NORTH AMERICA, INC.