41 11 028 Replacing Left Engine Carrier (Partial Replacement Before Front Axle)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2013 BMW 135is, 2013 BMW 135i, 2013 BMW 128i, 2012 BMW 135i, and 2012 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of Body, General . Refer to 41 0 Contents Of Body, General .

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Place vehicle on straightening bench.

Following new body parts are required (refer to EPC):

(1) Partial section, engine carrier

Fig 1: Identifying Partial Section, Engine Carrier
Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut (1) in middle of 20 mm dia. bore and cut.

Preparation of new part:

Mark severance cut (1) in accordance with vehicle and cut.

Installation:

Adjust all new parts to fit with straightening attachment or universal mount.

Weld in reinforcement plate at severance cut. Refer to 41 11 028 Replacing Left Engine Carrier (Partial Replacement Before Front Axle) .

Fig 2: Marking Severance Cut In Accordance With Vehicle

Courtesy of BMW OF NORTH AMERICA, INC.