41 5.... Removing And Installing Door

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2013 BMW 135is, 2013 BMW 135i, 2013 BMW 128i, 2012 BMW 135i, and 2012 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage adjoining body parts.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Release screw on connector frame.

Front door:

Tightening torque, see 41 51 4AZ in 41 51 FRONT DOORS .

Fig 1: Locating Screw On Connector Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (1) on door retainer.

Front door:

Tightening torque, see 51 21 3AZ in 51 21 FRONT DOOR LOCKS .

Fig 2: Identifying Screw On Door Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Secure door against falling out.

Release screws between both hinge elements at top and bottom.

Pull both screws out of hinges.

Front door:

Tightening torque, see 41 51 1AZ in 41 51 FRONT DOORS .

Fig 3: Locating Hinges Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out door sideways and place it on a suitable surface.

Fig 4: Pulling Out Door Sideways

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Installation:

If necessary, adjust door . Refer to 41 51.... Adjusting Door .

Fig 5: Pulling Plug Connection From Door Pillar, Unlock By Pulling Out Bar & Detach

Courtesy of BMW OF NORTH AMERICA, INC.