41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2013 BMW 135is, 2013 BMW 135i, 2013 BMW 128i, 2012 BMW 135i, and 2012 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Danger of injury!

The BATTERY NEGATIVE LEAD must be clamped off on vehicles with AFGS active pedestrian protection!

IMPORTANT:

Adhere to the following safety information so as to avoid a danger of injury by the actuator:

- Support engine compartment lid in fully opened position with suitable apparatus.

- Removal of the engine compartment lid must be carried out with the assistance of a second person.

Follow instructions on ACTIVE PEDESTRIAN PROTECTION SYSTEM .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD .

Release GAS STRUT FOR ENGINE BONNET/HOOD on engine compartment lid.

Unscrew nuts (1).

Remove engine compartment lid.

Installation note:

Install engine compartment lid at screw locations to on hinge.

Tightening torque: 15 Nm.

If necessary, ADJUST ENGINE COMPARTMENT LID .

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.