LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1934 (Collision - Body Panel Repair (E82)) >> Body Panel Repair >> 41 00... Notes On Adhesive K2 >> Adhesive application

Adhesive application

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2013 BMW 135is, 2013 BMW 135i, 2013 BMW 128i, 2012 BMW 135i, and 2012 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Read the vehicle-specific repair instructions to determine the thickness and positioning of the adhesive bead.

After applying the adhesive, check whether an adhesive component has emerged at the back of the glue cartridge. If yes, break off the bonding procedure. Clean new part. Use new glue cartridge. Contact national hotline.

Remove contamination caused by adhesive residue immediately.

Hardened adhesive can only be removed mechanically.

scientia non olet · About LEMON Manuals