Hexagon Rivet Nut (From M10 Thread)
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2013 BMW 135is, 2013 BMW 135i, 2013 BMW 128i, 2012 BMW 135i, and 2012 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Ensure correct screw length. The complete thread length of the rivet nut must be used for installation.
Make sure hexagon rivet nut correctly contacts component.
Replace screw after use.
- Insert screw (tensile strength min. 10.9) with body washer into hexagon rivet nut
- Insert hexagon rivet nut into pre-punched hexagon hole and install by turning screw
Notes on installation:
Rivet nut is upset (screw very difficult to move).
Rivet nut is contracted (screw comparatively easy to move).
Rivet nut is pressed onto the component (screw slowly becomes difficult to move). Procedure is finished with the fitting of the relevant component and its tightening torque.