61 31 192 Replacing Knob For Controller

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

00 9 317 TRIM PANEL WEDGE

IMPORTANT: Before dismantling the button it is imperative to note whether the controller is installed with a version before or after 09/2008!

NOTE: The number of buttons and shape of controller can vary depending on vehicle type. Before 09/2008: Controller (1) has buttons on bottom only. After 09/2008: Controller (2) has buttons top and bottom. Button may be removed from controller (1) only!

Fig 1: Identifying Number Of Buttons And Shape Of Controller

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: These repair instructions describe the removal of the button from controller (1)!

Partially fit special tool 00 9 317 as illustrated.

Lever out knob for controller (1) in direction of arrow and pull off.

Fig 2: Identifying Controller

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Risk of damage!

Install knob for controller only when controller is installed.

Installation:

Fit knob for controller (1) so that guides (2) are correctly seated in mountings (3).

Press knob for controller (1) in middle until it engages.

Fig 3: Identifying Controller & Guides

Courtesy of BMW OF NORTH AMERICA, INC.