61 67 120 Removing And Installing/Replacing High-Pressure Nozzle (Housing) Of Headlight Washer System (M/Aerodynamic Kit) On Left

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

13 3 010 HOSE CLIP and/or 13 3 010 HOSE CLIP

Necessary preliminary tasks:

Remove bumper trim . See 51 11 156 REMOVING AND INSTALLING/REPLACING FRONT BUMPER TRIM .

To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010 .

Catch any escaping washer fluid if necessary.

Fig 1: Identifying Special Tool (13 3 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and feed high-pressure nozzle of headlight washer system (4) out of holder (5).

Raise retaining clip (3) in direction of arrow and detach high-pressure line (2) from high-pressure nozzle of headlight washer system (4).

Installation:

Keep plug connection for high-pressure nozzle (4) and high-pressure line (2) clean and free from grease.

Make sure high-pressure line (2) is correctly engaged on high-pressure nozzle (4).

Fig 2: Identifying Feed High-Pressure Nozzle & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Guide (6) of high-pressure nozzle (4) must be threaded into associated mounting of holder (5).

Carry out a function test before fitting bumper trim.

If necessary, top up washer fluid.

Replacement:

Remove spray nozzle (nozzle head).