61 67 075 Removing And Installing/Replacing Spray Nozzles (Nozzle Heads) Of Headlight Washer System On Left Or Right (M/Aerodynamic Kit)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Catch any escaping washer fluid if necessary.

Raise cover for headlight washer system (1) with nozzle head (2) in direction of arrow.

IMPORTANT:

Risk of damage!

When releasing retaining lug (3), grip housing of high-pressure nozzle (5) and then allow to slide back slowly.

Fig 1: Identifying Headlight Washer System With Nozzle Head

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock retaining lug (3) with a suitable tool.

Remove cover for headlight washer system (1) with nozzle head (2) from high-pressure nozzle housing (5).

Release cover for headlight washer system (1) at attachment points (6) from nozzle head (2).

Installation:

Make sure sealing ring (4) is correctly fitted on nozzle head (2).

Nozzle head (2) must engage audibly on high-pressure nozzle housing (5).

If necessary, top up washer fluid.