51 23 211 Removing and installing/replacing cable for front engine hood locks (to passenger compartment)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Disconnect CABLE FOR HOOD/BONNET LOCKS
Remove LOWER SECTION OF MICROFILTER HOUSING .
Remove TRIM PANEL FOR PEDAL ASSEMBLY
Remove footwell SIDE TRIM PANEL on A-pillar

Release screws (1).

Remove fixture (2) and feed out Bowden cable (3).

Fig 1: Identifying Fixture And Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Feed Bowden cable (1) out of grommet (2).

Carefully feed Bowden cable (1) with grommet (3) out of vehicle interior.

IMPORTANT: Make sure grommets (2 and 3) are correctly seated (water ingress).

Installation:

Lay Bowden cable (1) without kinks.

Fig 2: Identifying Bowden Cable And Grommet

Courtesy of BMW OF NORTH AMERICA, INC.