33 17 005 Replacing rubber mount for rear differential mounting at rear

WARNING: This page is about a different car, the 2009 BMW 550i and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 4 281 . See REAR AXLE - SPECIAL TOOLS .
33 4 282
33 4 283
33 4 284
33 4 465
33 4 466

Necessary preliminary tasks:

Remove rear differential

Withdraw rubber mount with special tools 33 4 282, 33 4 281 , 33 4 466, 33 4 465 and nut (1).

Fig 1: Identifying Special Tools (33 4 281, 33 4 466 And 33 4 465) And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circo Light.

Align rubber mount horizontally by way of elongated hole (1).

Fig 2: Identifying Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount (1) in special tool 33 4 283.

Draw in rubber mount (1) with special tools 33 4 282 , 33 4 283 , 33 4 284 , 33 4 466 , 33 4 465 and nut (2) as far as it will go.

NOTE: Make sure special tools 33 4 283 and 33 4 284 contact rear axle carrier correctly.

Fig 3: Identifying Special Tool (33 4 282, 33 4 283 And 33 4 284) And Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.