51 41 ... Replacing door pocket on front left or right door trim panel

WARNING: This page is about a different car, the 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT DOOR TRIM PANEL

IMPORTANT: Only drill down to door trim panel area (2) so as not to damage the contact surface.

Drill out welding spots (1) on door trim panel (2) with 8 mm dia. welding spot drill bit and remove door pocket.

NOTE: Door pocket is welded to door trim panel only on initial installation.

If necessary, release nuts instead of welding spots (1).

Fig 1: Identifying Welding Spots On Door Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Secure door pocket with nuts (1) to door trim panel (2).

Fig 2: Identifying Door Pocket With Nuts

Courtesy of BMW OF NORTH AMERICA, INC.