51 32 420 Removing and installing/replacing trim on front door window frame, left or right

Necessary preliminary tasks: 

• Remove WINDOW CAVITY COVER STRIP ON OUTSIDE OF FRONT DOOR 

Partially detach rubber window seal (1) at rear.

Fig 1: Identifying Rubber Window Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove finisher (2) and press approx. 3 mm towards rear.

Fig 2: Identifying Finisher And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove trim (1) towards top.

Fig 3: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

All except Security version.

Following parts must not be damaged or missing:

1. Plastic nuts
2. Felt strip
3. Seal

Fig 4: Identifying Plastic Nuts, Felt Strip And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Security version: 

M5 pull-in nuts (1) must not be damaged or missing.

Trim is designed as a protective cover and is screwed into place with M5 X 20 mm stainless steel screws without shims.

Fig 5: Identifying M5 Pull-In Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check trim (1) for damage, replace if necessary.

Fig 6: Identifying Trim

Courtesy of BMW OF NORTH AMERICA, INC.