51 11 ... Installing/replacing license plate (without base)

WARNING: This page is about a different car, the 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Tightening torque 51 11 7AZ .

Fit protective caps.

Fig 1: Identifying Template And Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure license plate (3) with license plate screw (4).

Tightening torque 51 11 8AZ .

Fig 2: Identifying License Plate, Rivet Nut And Screws

Courtesy of BMW OF NORTH AMERICA, INC.