34 32 861 Replacing all brake pipes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
NOTE:
The brake lines are only supplied in the straight version and correct length with connecting nipple.
Read and comply with GENERAL INFORMATION .
After completing work, BLEED BRAKE SYSTEM .
Observe SAFETY INSTRUCTIONS on raising the vehicle.
Read and comply with GENERAL INFORMATION .
After completing work, BLEED BRAKE SYSTEM .
Observe SAFETY INSTRUCTIONS on raising the vehicle.
New brake lines are bent into shape with bending tool 34 5 100 .
Removed brake pipes can be used as templates for bending.
IMPORTANT:
- Protective coating of brake line must not be damaged during bending.
- Do not kink or bend back brake lines.
- Watch distances to rigid and movable vehicle parts. Brake lines may not make contact or rub.
- Tighten down brake line couplings with torque wrench.
Installation:
Tightening torque 34 32 1AZ .