34 00 050 Bleeding brake system with DSC

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Observe the filling and bleeding instructions when replacing or repairing:

Replace
Hydraulic unit
Components and connecting lines which are fitted between these assemblies.

Connect bleeder unit with max. 2 bar filling pressure.

A second person is needed to help carry out this work.

IMPORTANT: Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.

Connect BMW Diagnosis and Information System (DIS).
Select path: Service functions - Chassis/Suspension - Slip control systems - Bleeding procedure.
Connect bleeder unit to expansion tank and switch on.

Fig 1: Connecting Bleeder Unit To Expansion Tank
Courtesy of BMW OF NORTH AMERICA, INC.

Flushing brake system completely

Connect bleeder hose with collecting tray to bleeder valve on rear right brake caliper.

Open bleeder valve and purge until clear, bubble-free brake fluid emerges.

Close bleed valve.

Follow same procedure on rear left, front right and front left wheel brake.

Fig 2: Connecting Bleeder Hose With Collecting Tray To Bleeder Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Bleeding rear-axle brake circuit

Connect bleeder hose with collecting tray to bleeder valve on rear right brake caliper.

Close bleeder valve.

Run through bleeding routine with BMW Diagnosis and Information System (DIS) with bleeder valve open.

After completing routine, press brake pedal 5 times to floor, clear and bubble-free brake fluid must flow out.

Close bleed valve.

Repeat procedure at rear left.

Fig 3: Connecting Bleeder Hose With Collecting Tray To Bleeder Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Bleeding front-axle brake circuit

Connect bleeder hose with collecting tray to bleeder valve on front right brake caliper.

Close bleeder valve.

Run through bleeding routine with BMW Diagnosis and Information System (DIS) with bleeder valve open.

After completing routine, press brake pedal 5 times to floor, clear and bubble-free brake fluid must flow out.

Close bleed valve.

Repeat procedure at front left.

Fig 4: Connecting Bleeder Hose With Collecting Tray To Bleeder Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Switch off brake fluid changer and remove from expansion tank.

Check brake fluid level. If necessary, top up/draw off to max. level.

Close expansion tank.

NOTE: Pay attention to rubber seal (1) in sealing cap.

Fig 5: Identifying Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.